Underfloor Heating by Future Proof Energy - clean, simple, discreet and economical way to heat your home or office
Underfloor heating requires less energy to heat a space than traditional radiators, reducing energy costs on average between 15% and 40%. They are simple to install and can be combined with other heat distribution systems where necessary.
- A low temperature system, which can be used with a variety of heat sources including renewable energy solutions.
- Heat is more evenly distributed around the space preventing hot spots and creating a more comfortable environment.
- Installation is fast and simple using a clip-rail system of staples.
- A full range of wired and wireless controls is available to suit any project.
Wet underfloor heating is suitable for use anywhere throughout a building. Most commonly, it is installed with a screeded floor but systems are available for most types of construction. It can be fitted underneath almost any floor finish, from carpet to laminate.
What an amazing value!
Below, please find the cost comparison between 3 suppliers of underfloor heating solutions based on the 150 sq m house (bathroom, kitchen, livingroom and 3 bedrooms) with only average thermal insulation. On this particular example, underfloor heating system is equipped with programmable room thermostat allowing the full control over each individual heating loop (greater comfort and energy saving at the same time):
 |
 |
 |
| 750 meters of PB pipe. Please remember our assumption with regards to only average insulation of the house. Better insulation equals less pipe.
|
750 meters of PEX pipe.
Please remember our assumption with regards to only average insulation of the house. Better insulation equals less pipe.
|
750 meters of PE-RT/AI/PE-HD (combination of PVC and aluminum) multi-layer pipe. Example house is only averagely insulated. Better insulation equals less pipe.
|
| Edge insulation tape | Edge insulation tape | Edge insulation tape |
| 7 port manifold equipped with modulating pump unit with UFCH mixer valve and thermometer | 7 port manifold equipped with modulating pump unit with UFCH mixer valve and thermometer | 7 port manifold equipped with modulating pump unit with UFCH mixer valve and thermometer |
| 7 actuators | 7 actuators | 7 actuators |
| Electronic controls over 6 independent heating loops | Electronic controls over 6 independent heating loops | Electronic controls over 6 independent heating loops |
| RRP: £2,800.00 | RRP: £2,846.00 | RRP: £2,054.00 |
On that particular example, Underfloor Heating by KAN-therm System supplied exclusively by Future Proof Energy is nearly £800.00 (!) less expensive than direct competition with like for like comparison. This is an example cost only. Please note that substantial discounts are available on complete systems supplied and installed by us.
Please contact us for details.
Wet systems use low pressure warm water pumped through concealed loops of pipe work - they are easy to install at any stage of the project whether a new build or a refurbishment. Wet underfloor heating systems normally utilize hot water from central heating systems. Air / Ground Heat Pumps and Condensing Boilers are well suited to 'power' underfloor heating as they are more cost effective. Unlike radiators, the underfloor heating system can run at much lower temperatures as the system is spread out over a vast area. This increases the overall feeling of warmth and comfort in a property.
